Aeronautical Terms beginning with G

GA CDR

General Aviation Coded Departure Routes (GA CDR) - The CDR program provides a rapid means to reroute aircraft when the filed route is constrained by either weather or congestion. Historically, abbreviated CDR clearances have only been issued to airline customers who have signed a Memorandum of Agreement (MOA) with the facilities that issue abbreviated CDR clearances. Recently, general aviation customers have requested the use of this reroute capability. This change permits general aviation customers to communicate to Air Traffic Control (ATC) facilities their ability and willingness to accept CDRs and their capability to accept abbreviated clearances associated with CDRs. Please see the GA CDR Advisory circular for more details.

Gas Generator

The basic power producing portion of a gas turbine engine and excluding such sections as the inlet duct, the fan section, free power turbines, and tailpipe. Each manufacturer designates what is included as the gas generator, but generally consists of the compressor, diffuser, combustor, and turbine.

Gas Turbine Engine

A form of heat engine in which burning fuel adds energy to compressed air and accelerates the air through the remainder of the engine. Some of the energy is extracted to turn the air compressor, and the remainder accelerates the air to produce thrust. Some of this energy can be converted into torque to drive a propeller or a system of rotors for a helicopter.

Gate Hold Procedures

Procedures at selected airports to hold aircraft at the gate or other ground location whenever departure delays exceed or are anticipated to exceed 15 minutes. The sequence for departure will be maintained in accordance with initial call-up unless modified by flow control restrictions. Pilots should monitor the ground control/clearance delivery frequency for engine start/taxi advisories or new proposed start/taxi time if the delay changes.

GDP

Ground Delay Program. Ground Delay Programs are implemented to control air traffic volume to airports where the projected traffic demand is expected to exceed the airport´s acceptance rate for a lengthy period of time. Lengthy periods of demand exceeding acceptance rate are normally a result of the airport´s acceptance rate being reduced for some reason. The most common reason for a reduction in acceptance rate is adverse weather such as low ceilings and visibility.
How it works: Flights that are destined to the affected airport are issued Expect Departure Clearance Times (EDCT) at their point of departure. Flights that have been issued EDCTs are not permitted to depart until their Expect Departure Clearance Time. These ECDTs are calculated in such a way as to meter the rate that traffic arrives at the affected airport; ensuring that demand is equal to acceptance rate. The length of delays that result from the implementation of a Ground Delay Program is a factor of two things; how much greater than the acceptance rate the original demand was, and for what length of time the original demand was expected to exceed the acceptance rate.

GLS

Global Landing System.

Go-around power or thrust setting

The maximum allowable in-flight power or thrust setting identified in the performance data.

Goniometer

As used in radio frequency (RF) antenna systems, a direction-sensing device consisting of two fixed loops of wire oriented 90° from each other, which separately sense received signal strength and send those signals to two rotors (also oriented 90°) in the sealed direction-indicating instrument. The rotors are attached to the direction-indicating needle of the instrument and rotated by a small motor until minimum magnetic field is sensed near the rotors.

GPWS

Ground Proximity Warning System.

Gross Navigation Error (GNE)

In the North Atlantic area of operations, a gross navigation error is a lateral separation of more than 25 NM from the centerline of an aircrafts cleared route, which generates an Oceanic Navigation Error Report. This report is also generated by a vertical separation if you are more than 300 feet off your assigned flight level.

Ground Delay Program (GDP)

A traffic management process administered by the ATCSCC; when aircraft are held on the ground. The purpose of the program is to support the TM mission and limit airborne holding. It is a flexible program and may be implemented in various forms depending upon the needs of the AT system. Ground delay programs provide for equitable assignment of delays to all system users.

Ground Idle

Gas turbine engine speed usually 60-70 percent of the maximum r.p.m. range, used as a minimum thrust setting for ground operations.

Ground Power Unit (GPU)

A type of small gas turbine whose purpose is to provide electrical power, and/or air pressure for starting aircraft engines. A ground unit is connected to the aircraft when needed. Similar to an aircraft-installed auxiliary power unit.

Ground Stop (GS)

The GS is a process that requires aircraft that meet a specific criteria to remain on the ground. The criteria may be airport specific, airspace specific, or equipment specific; for example, all departures to San Francisco, or all departures entering Yorktown sector, or all Category I and II aircraft going to Charlotte. GSs normally occur with little or no warning.

Groundspeed Measurement System

A measurement system for determining the groundspeed of an aircraft during final approach and landing, by measuring at the aircraft the Doppler shift of a radio signal, and/or its modulation components, transmitted by a fixed ground station.

GS

Ground Stop. Ground Stops are implemented for a number of reasons. The most common reasons are:
To control air traffic volume to airports when the projected traffic demand is expected to exceed the airport´s acceptance rate for a short period of time.
To temporarily stop traffic allowing for the implementation of a longer-term solution, such as a Ground Delay Program.
The affected airport´s acceptance rate has been reduced to zero.
How it works: Flights that are destined to the affected airport are held at their departure point for the duration of the Ground Stop.

GSD

Geographical Situation Display

GUS

Ground Uplink Station

Gust Penetration Speed

The speed that gives the greatest margin between the high and low mach speed buffets.

GWPS